Aeon Labs ZW056 z-wave doorbell Gen5

After the Doorbell is paired into your Z-wave network, you can use your Z-Wave controller or mobile application to control its ringing, or configure its advanced functions. (Push button must be installed at the door prior using the system .DO NOT test the system while the pushbutton is in your hands ! ( Please install is first at the door or just put on the flat surface for testing purpose.)

Product Features

• Every press of Doorbell’s outdoor button notifies your connected home that someone is at the door, allowing you to receive notifications, a chime in the home, and to activate any devices attached to your Z-Wave system.
• Wirelessly communicating with Doorbell’s button. Doorbell speaker offers configurable volume and tones and simply plugs into any power outlet. Each speaker module is only 64.8mm wide, 92.3mm high, and 30.8 deep.
• Doorbell is easy to install. Its speaker simply plugs into a power outlet, and its button can be easily installed beside your front door with double-sided tape or small screws. You’ll find those easy installation methods provided in Doorbell’s box, along with the USB cable that’ll allow you change its alert tones.
• From outside to in, Doorbell uses ultra-low powered wireless communication. There’s no wiring necessary. Hear and see when someone is at your door via Doorbell’s LED light alerts and customisable tones.
• Works with HomeSeer ISY994Zw VeraEdge Z-Wave Gateway Controller – Set up parameter 80 = 1 (1 bit dec) to receive notifications and create scenes including the doorbell